RENT CHROMA 62015B-150-10 (call for availability)

The Chroma 62015B-150-10 DC Power Supply Module is engineered for efficiency and performance in various burn-in applications, including LCD panels, DC-DC converters, power inverters, notebook computers, and battery chargers. Its high power density coupled with low current ripple ensures cost-effectiveness while adhering to modern power factor correction circuitry that meets rigorous IEC requirements.

Key Features of the Chroma 62015B-150-10

• N+1 Redundancy for enhanced reliability
• Hot-Swappable Maintenance for uninterrupted operation
• Optimized for Burn-in and Plating applications
• High Power Applications compatibility with CSU
• Remote Sense to enhance voltage accuracy
• Remote ON / OFF functionality for operational flexibility
• CAN Bus Control for integrated system management
• DC OK Signal Output for operational status monitoring
• Voltage Range: 1 ~ 150V
• Current Range: Up to 2000A (System)
• Power Capability up to 1.5KW per module, scaling to 120KW per system
• Exceptional Power Density at 464 mW / cm³ (7.13 W/In³)

Specifications

Electrical Specifications:

• Output Ratings:
  • Output Power: 1500W
  • Output Voltage: 1~150V
  • Output Current: 1~10A
• Line Regulation: 0.1% FS
• Load Regulation: 1% FS
• Programming Accuracy: 1% FS
• Measurement Accuracy: 1% FS
• Output Noise (20MHz):
  • Voltage Noise (P-P): 400mV
  • Voltage Ripple (rms): 100mV
  • Current Ripple (rms): 0.1A
• Efficiency: > 88% @ full load
• Turn-On Over Shoot Voltage (Rise Time of 100ms): 5% of nominal output
• Transient Response Time: < 5 ms
• AC Input Voltage:
  • Six Position Mainframe: 187 ~ 250 Vac (3 Phase 4 Wire, Δ Connection) or 323 ~ 437 Vac (3 Phase 5 Wire, Y Connection) / 45 ~ 65 Hz
  • Three Position Mainframe: 187 to 250 Vac (single phase) / 45 ~ 65 Hz
  • Input Power Factor: > 0.98 @ full load

Protection Functions:

• OVP: Automatically shuts down at 115% of set value
• Adjustment Range: 1~155V
• OCP: Current limit (0 ~ 100%) / OCP Shutdown at 115% of F.S.
• OTP: Automatically shuts down if internal limit is reached

I/O Signal:

• Remote ON/OFF (I/P): Dry contact (closed = enabled), vice versa
• AUX Voltage: 4 ~ 24V / 0.5A at mainframe (by trimmer adjust voltage)
• DC OK Signal Type (O/P): Dry contact (closed = enabled) (Error: OVP / OCP / OTP / AC Fault)

Performance and General Specifications:

• Remote Sensing: 3V maximum line loss compensation
• Parallel Operation: Current Sharing (±5%)
• Operating Temperature: 0 ~ 50°C
• Humidity Range: 0 ~ 90% RH, Non-condensing
• Remote Interface: CAN Bus (optional)
• Safety & EMC: CE Certified